Sheet Metal and Spraying Process of Aluminum Plate Sheet

2022/08/02 Blog

Introduction of sheet metal and spraying process of aluminum plate sheet

Aluminum plate sheet metal processing technology:

Aluminum plate sheet processing technology for roughly : cutting - nc - bending (if it is a single board, before and after bending are need to roll arc) welding assembly - - - - polishing - check (sampling) between each working procedure.

Note: the processing cost of sheet metal processing is high in nc, bending and welding.In other words, as long as the aluminum plate sheet products need to go through these three processes, not only the cost of the process itself is higher, but also the cost of assembly and polishing process.? the corners of the plates supplied by our suppliers are not polished at right angles, and they are welded into rounded corners.2. Aluminum plate sheet spraying (fluorocarbon, powder) processing technology.

The coating process of aluminum plate sheet :

Pretreatment (this process contains about 10 ways of treatment) - roasting - primer spray - finish paint -- finish paint - baking;

1. There are two main types of pre-treatment in the industry: one is spray rail;The two kinds are pre-soaking;

2. The advantages of spray rail pretreatment are better to guarantee the spraying quality of aluminum plate sheet products, and have the characteristics of no secondary pollution, which is fully automatic in orbit.The disadvantages are high cost and relatively low efficiency (success, phnom penh is this);

3. The advantages of immersion pretreatment are low cost and high efficiency. The disadvantage is that the quality of the aluminum plate sheet cannot be fully guaranteed, and there is a risk of secondary pollution and scratch products.

Related Blog

5083 medium thick aluminum plate
2022/07/16
The 5083 medium-thick aluminum plate is a typical product of the 5-series high-magnesium alloy. Its light weight and high strength make the 5083 aluminum plate play a huge role in automobile manufacturing, shipbuilding and rail transportatio
View details
7175 super hard aluminum alloy
2021/11/05
The 7175 alloy is a typical aerospace super-hard aluminum, AL-Zn-Mg-Cu alloy. It is now the main material for the key structures of aerospace vehicles. Only in composite materials can be mass-produced
View details
5052 h34 aluminum plate
2022/02/22
5052 h34 aluminum plate has good corrosion resistance, excellent weldability, good cold workability, and medium strength. It has good plasticity during semi-cold work hardening and low plasticity during cold work hardening. It has poor machinability a
View details
7075 T651 pre-stretched thick aluminum plate
2022/07/19
7075 T651 pre-stretched thick aluminum plate is the main structural material in the fields of aviation, aerospace and other fields, and its internal stress is required to be small and uniform. The use of 7075 T651 pre-stretched thick alumin
View details